gm0mzb
9th July 2009, 09:52 PM
Hi all, with the new Sinclair Dual Isolator now installed, the repeater is now working on the single antenna.
The Isolator gives us about 75dB of isolation and is more stable than the the Airtech one previously used.
The antenna is now installed in its new permanent location with new LDF4-50 Heliax, so some signal reports would be appriciated.
Over the next few weeks I will construct a new duplexer harness with Mil spec RG223 low loss coax, and give the filters a tune up.
Hopefully hear you on
Wullie
The Isolator gives us about 75dB of isolation and is more stable than the the Airtech one previously used.
The antenna is now installed in its new permanent location with new LDF4-50 Heliax, so some signal reports would be appriciated.
Over the next few weeks I will construct a new duplexer harness with Mil spec RG223 low loss coax, and give the filters a tune up.
Hopefully hear you on
Wullie